Swimwear care guide

It is important to take proper care of your UV clothing. Sun, salt water, chlorine and sunscreen can be stressful for your swimwear and cause colour to fade, but with the right kind of care your swimwear should take you through seasons of fun! Read our tips below to keep your UPF50+ swimwear looking good and functional. 
 

Shower first

You’re practicing good hygiene by having a shower before hitting the pool, but there’s another advantage to a pre-shower. Pool water contains chlorine and other chemicals, which are harmful to swimwear fabric. If you have a shower before going in the pool, the fabric of your UPF50+ swimwear absorbs ‘regular’ water and then there’s less room for those nasty substances in the pool water to get in.

Rinse well

Rinse you swimwear in cold water after each use. If it is necessary to wash your UPF50+ swimwear, always do this by hand. Fill your sink with cold water and add some mild soap. Wash gently and rinse well with cold water. Do not soak your swimwear as this is bad for the fibers and causes them to loose their elasticity. Don’t wring your swimwear. This causes the elastic to weaken and that will directly effect the fit of your swimwear. 

How to dry your UPF50+ swimwear

Do not leave your UV clothing rolled up in a towel or bath towel after use, otherwise the chlorine will have more time to penetrate the fabric and your UV clothing may become moldy. It is best to let your UV clothing dry in the open air and in the shade after you have rinsed it. Never dry your swimwear in the direct sun or near a heater. Do not hang your UV clothing to dry on a metal hanger, as this can cause rust stains and these stains will be impossible to remove. UV clothing should absolutely not be put in the dryer!

Colour fading

Despite the color fastness of our UV clothing, it cannot be ruled out that discoloration may occur under certain circumstances. High levels of chlorine, sunlight and salt content in the sea can damage your UV clothing and cause color changes. Some brands of sunscreen can also leave (yellow) stains in the fabric that you cannot remove. Therefore, apply sunscreen 20 minutes before putting on your swimwear. If you need to reapply, try to avoid any contact with the fabric.

Rough surfaces and slides

If you’re planning an active day at the water park or maybe by the rock pools, think about wearing your old swimsuit. Rough surfaces such as concrete, benches and other rough materials can damage the fabric, snagging it or creating worn areas. Don’t sit on rough surfaces while wearing your UPF50+ swimwear. Put down a towel first. Slides are cool attractions in the pool, but your UPF50+ swimwear can wear out faster because of this. Weak spots, fabric that pills and/or holes are the result.

Sand

As with all swimwear, sand can sometimes get caught in the fibers of the fabric. The density of the fabric can make it more difficult to wash out dirt or sand, which can sometimes cause stains to remain. To remove stuck sand, gently run your fingernail over the fabric when the fabric is dry.